Bronco.com HOME
 

---------

---------

RE: D60 ?

From: Dusenberry, Quinn <quinn.dusenberry_at_red.gd-ots.com>
Date: Fri, 1 Feb 2002 09:31:28 -0800

James Duff is now selling the ears as a separate item. I think they are
about $70 for the pair. Pretty cool new product, IMO.

-----Original Message-----
From: Covert, Jack [mailto:JACOVERT_at_compucom.com]
Sent: Friday, February 01, 2002 6:54 AM
To: rjlougee; Allen Fahey
Cc: EBML
Subject: RE: [EBML] D60 ?


Hey Allen,
 
Where'd you get your ears?

        -----Original Message-----
        From: rjlougee
        Sent: Fri 2/1/2002 9:46 AM
        To: Allen Fahey
        Cc: EBML
        Subject: Re: [EBML] D60 ?
        
        

        Let me take a shot at this Allen, I'm planning to do mine soon
and this
        way the list can ixnay it if insufficiently thought through.
        
        My basic plan is to loosely assemble the front end and make some
        measurements of the floor and knuckles. The axle on jackstands
and at
        normal ride height in relation to the frame/body. Use an angle
finder
        on the floor under the front of the EB and again on the top of
the
        knuckles. Adjust the angle of the knuckles, by rotating the
axle until
        the desired caster is achieved. Tack weld the C-bushing
brackets on the
        tubes, remove and finish weld.
        
        I.e. If I'm looking for 5 degrees of caster, I'll measure the
angle at
        the floor to make sure it's zero. Then measure the angle on the
        knuckles. Assuming the floor was at zero, the axle will be
rotated
        until the knuckle is at 5 degrees. I would do this to both
sides to
        ensure it's not slightly twisted in the bushings. Anything
other than
        zero on the floor will cause the 5 degrees to be added to the
base
        figure.
        
        Did that make sense and is it a viable plan?
        Joe
        
        ------------------------------
        Early Bronco Mailing List (EBML)
        Unsubscribe: majordomo_at_bronco.com unsubscribe EBML
youremailid_at_yourisp.com
        in the messagebody.
        To modify your account (switch to digest or to real-time), goto:
        http://mail.bronco.com/cgi-bin/mj_wwwusr/domain=bronco.com/EBML.
        Admin address: EBML-owner_at_bronco.com
        

------------------------------
Early Bronco Mailing List (EBML)
Unsubscribe: majordomo_at_bronco.com unsubscribe EBML youremailid_at_yourisp.com
in the messagebody.
To modify your account (switch to digest or to real-time), goto:
http://mail.bronco.com/cgi-bin/mj_wwwusr/domain=bronco.com/EBML.
Admin address: EBML-owner_at_bronco.com
Received on Fri Feb 01 2002 - 10:34:53 MST


Email us at: info@bronco.com
Many thanks to our contributors.
© 1996 - 2016 www.Bronco.com