Bronco.com HOME
 

---------

---------

Re: [Bfix] rear end help

From: Chris <broncosaurus1_at_yahoo.com>
Date: Mon, 11 Feb 2002 17:59:26 -0800 (PST)

You could try using a brake cylinder honing tool to
remove any ridges that have built up, if the tool is
big enough. Is this a new bearing? Could it not be
pressed all the way into place?

--- Donald Jones <jrjones78_at_msn.com> wrote:
> I am trying to get my short side axel to slide in
> and I can get the axel
> splines to slide in to the diff but the bearing wont
> slide into the end of
> the tube.the other side slid right inwith a little
> help.
> Any advice would be appreciated. Or it BFH time in
> the Jones garage.
> Thanks
> Don
>
>
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>
> For Broncofix list addition and removal, go to
> http://www.broncofix.com
> Check out our new message board at
> http://www.broncofix.com/board!!!
> For additional assistance, email the admin at
admin_at_broncofix.com


=====
Chris from Issaquah
'68 U14NL...
Blue-ish

__________________________________________________
Do You Yahoo!?
Send FREE Valentine eCards with Yahoo! Greetings!
http://greetings.yahoo.com
Received on Mon Feb 11 2002 - 18:59:28 MST


Email us at: info@bronco.com
Many thanks to our contributors.
© 1996 - 2016 www.Bronco.com