Re: '85 HO and Clutch Linkage

From: Lars Pedersen <>
Date: Tue, 12 Feb 2002 09:46:17 -0800

Check out the following site, 4th and 5th pictures down. They show a stock
arm with plates welded to it to attach to the bellhousing bolts. I copied
this bracket. Works fine.

Lars Pedersen
Davis, Ca

At 15:22 02/11/2002 -0500, you wrote:
>Haven't worked on my bronco in months. I finally got around to bolting
>on my new clutch and bellhousing last night. I'm swapping in an '85
>Mustang HO as well. Has anyone else done this swap, or similiar, with a
>manual tranny? The mustang block doesn't seem to have the same tapped
>hole for part of the clutch linkage that the bronco block had. I'm
>talking about the arm that bolts to both the bellhousing and the block.
>I 'm not sure what the part is really called. I didn't bolt anything up
>yet as I was quite confused. Anyone run into this before? Thanks.
>Matt in Annapolis
>Early Bronco Mailing List (EBML)
>Unsubscribe: unsubscribe EBML
>in the messagebody.
>To modify your account (switch to digest or to real-time), goto:
>Admin address:
Received on Tue Feb 12 2002 - 10:42:29 MST

Email us at:
Many thanks to our contributors.
© 1996 - 2016